NetApp AFF A Series User Manual

a. Point your browser to the node management IP address.
The format for the address is https://x.x.x.x.
b. Configure the system using the data you collected in the
ONTAP Configuration Guide.
5. Verify the health of your system by running Config Advisor.
6. After you have completed the initial configuration, go to the
ONTAP & ONTAP System Manager
Documentation Resources
page for information about configuring additional features in ONTAP.
Maintain
Boot media
Overview of boot media replacement - AFF A800
• You must replace the failed component with a replacement FRU component you received from your
provider.
• It is important that you apply the commands in these steps on the correct controller:
◦ The impaired controller is the controller on which you are performing maintenance.
◦ The healthy controller is the HA partner of the impaired controller.
Check onboard encryption keys - AFF A800
Prior to shutting down the impaired controller and checking the status of the onboard
encryption keys, you must check the status of the impaired controller, disable automatic
giveback, and check what version of ONTAP the system is running.
Prior to shutting down the impaired controller and checking the status of the onboard encryption keys, you
must check the status of the impaired controller, disable automatic giveback, and check the version of ONTAP
that is running.
If you have a cluster with more than two nodes, it must be in quorum. If the cluster is not in quorum or a healthy
controller shows false for eligibility and health, you must correct the issue before shutting down the impaired
controller; see the
Synchronize a node with the cluster.
Steps
1. Check the status of the impaired controller:
◦
If the impaired controller is at the login prompt, log in as
admin.
◦
If the impaired controller is at the LOADER prompt and is part of HA configuration, log in as
admin on
the healthy controller.
◦ If the impaired controller is in a standalone configuration and at LOADER prompt, contact
mysupport.netapp.com.
2. If AutoSupport is enabled, suppress automatic case creation by invoking an AutoSupport message:
system node autosupport invoke -node * -type all -message
MAINT=number_of_hours_downh
The following AutoSupport message suppresses automatic case creation for two hours: cluster1:*>
system node autosupport invoke -node * -type all -message MAINT=2h
592

NetApp AFF A Series Specifications

General

Brand	NetApp
Model	AFF A Series
Category	Server
Language	English