EasyManuals Logo

NetApp AFF A Series User Manual

NetApp AFF A Series
808 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #616 background imageLoading...
Page #616 background image
â—¦
If the
Key Manager type = onboard and the Restored column = anything other than yes/true,
use the
security key-manager onboard sync command to re-sync the Key Manager type.
Use the security key-manager key query to verify that the
Restored column = yes/true for all
authentication keys.
11. Connect the console cable to the partner controller.
12.
Give back the controller using the
storage failover giveback -fromnode local command.
13.
Restore automatic giveback if you disabled it by using the
storage failover modify -node local
-auto-giveback true
command.
14.
Restore Autosupport if it was disabled by using the
system node autosupport invoke -node *
-type all -message MAINT=END
Return the failed part to NetApp - AFF A800
Return the failed part to NetApp, as described in the RMA instructions shipped with the
kit. See the
Part Return & Replacements page for further information.
Chassis
Replace the chassis - AFF A800
To replace the chassis, you must move the bezel, controller modules, and NVMe drives
from the impaired chassis to the replacement chassis, and then remove the impaired
chassis from the equipment rack or system cabinet and install the replacement chassis in
its place.
All other components in the system must be functioning properly; if not, you must contact technical support.
• You can use this procedure with all versions of ONTAP supported by your system.
• This procedure is written with the assumption that you are moving the bezel, NVMe drives, and controller
modules to the new chassis, and that the replacement chassis is a new component from NetApp.
• This procedure is disruptive. For a two-node cluster, you will have a complete service outage and a partial
outage in a multi-node cluster.
Shut down the controllers - AFF A800
This procedure is for 2-node, non-MetroCluster configurations only. If you have a system
with more than two nodes, see
How to perform a graceful shutdown and power up of one
HA pair in a 4-node cluster
.
Before you begin
You need:
• Local administrator credentials for ONTAP.
• NetApp onboard key management (OKM) cluster-wide passphrase if using storage encryption.
• SP/BMC accessability for each controller.
• Stop all clients/host from accessing data on the NetApp system.
614

Other manuals for NetApp AFF A Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NetApp AFF A Series and is the answer not in the manual?

NetApp AFF A Series Specifications

General IconGeneral
BrandNetApp
ModelAFF A Series
CategoryServer
LanguageEnglish

Related product manuals