NetApp AFF A220 User Manual

FAS2700 System Documentation
Install and setup
Start here: Choose your installation and setup experience
For most configurations, you can choose from different content formats.
•
Quick steps
A printable PDF of step-by-step instructions with live links to additional content.
•
Video steps
Video step-by-step instructions.
•
Detailed steps
Online step-by-step instructions with live links to additional content.
If your system is in a MetroCluster IP configuration, see the
Install MetroCluster IP Configuration instructions.
Quick guide - AFF A220 and FAS2700
This guide gives graphic instructions for a typical installation of your system from racking
and cabling, through initial system bring-up. Use this guide if you are familiar with
installing NetApp systems.
Access the Installation and Setup Instructions PDF poster:
AFF A220/FAS2700 Systems Installation and Setup Instructions
Videos - AFF A220 and FAS2700
There are two videos; one showing how to rack and cable your system and one showing
an example of using the System Manager Guided Setup to perform initial system
configuration.
Video one of two: Hardware installation and cabling
The following video shows how to install and cable your new system.
NetApp video: AFF A220 and FAS2700 Systems: Installation and Setup Instructions
Video two of two: Performing end-to-end software configuration
The following video shows end-to-end software configuration for systems running ONTAP 9.2 and later.
NetApp video: Software configuration for vSphere NAS datastores for FAS/AFF systems running ONTAP 9.2
1

NetApp AFF A220 Specifications

General

Form Factor	2U
Drive Types	SSD
Maximum Drives	24
Operating System	ONTAP
Maximum Memory	256GB
Processor	Intel Xeon
Memory	128GB per controller
Redundancy	Yes
Connectivity	10 GbE, 25 GbE, 40 GbE, 100 GbE, FC
Protocols Supported	FC, iSCSI, NFS, SMB/CIFS, NVMe/FC
RAID Support	RAID-DP, RAID-TEC
Operating System Version	ONTAP
Power Supply	Dual
Controller	Dual controller