node1_siteA::> metrocluster node show -fields configuration-state
dr-group-id cluster node configuration-state
----------- ---------------------- --------------
-------------------
1 node1_siteA node1mcc-001 configured
1 node1_siteA node1mcc-002 configured
1 node1_siteB node1mcc-003 configured
1 node1_siteB node1mcc-004 configured
4 entries were displayed.
10.
Verify that the expected volumes are present for each node:
vol show -node node-name
11.
If you disabled automatic takeover on reboot, enable it from the healthy node:
storage failover
modify -node replacement-node-name -onreboot true
Complete system restoration - AFF A900
To complete the replacement procedure and restore your system to full operation, you
must recable the storage, restore the NetApp Storage Encryption configuration (if
necessary), and install licenses for the new controller. You must complete a series of
tasks before restoring your system to full operation.
Step 1: Install licenses for the replacement node in ONTAP
You must install new licenses for the replacement node if the impaired node was using ONTAP features that
require a standard (node-locked) license. For features with standard licenses, each node in the cluster should
have its own key for the feature.
About this task
Until you install license keys, features requiring standard licenses continue to be available to the replacement
node. However, if the impaired node was the only node in the cluster with a license for the feature, no
configuration changes to the feature are allowed. Also, using unlicensed features on the node might put you
out of compliance with your license agreement, so you should install the replacement license key or keys on
the replacement node as soon as possible.
The licenses keys must be in the 28-character format.
You have a 90-day grace period in which to install the license keys. After the grace period, all old licenses are
invalidated. After a valid license key is installed, you have 24 hours to install all of the keys before the grace
period ends.
If the node is in a MetroCluster configuration and all nodes at a site have been replaced, license keys must be
installed on the replacement node or nodes prior to switchback.
1. If you need new license keys, obtain replacement license keys on the NetApp Support Site in the My
Support section under Software licenses.
NetApp Support
70
To Next Page
Loading...
