The following options show you how to cable one or two NS224 drive shelves to your system.
=== Option 1: Cable the controllers to a single drive shelf
You must cable each controller to the NSM modules on the NS224 drive shelf.
About this task
Be sure to check the illustration arrow for the proper cable connector pull-tab orientation. The cable pull-
tab for the NS224 are up.
As you insert the connector, you should feel it click into place; if you do not feel it click,
remove it, turn it around and try again.
Steps
1. Use the following illustration to cable your controllers to a single drive shelf.
2. Go to [Step 5: Complete system setup and configuration] to complete system setup and configuration.
=== Option 2: Cable the controllers to two drive shelves
You must cable each controller to the NSM modules on both NS224 drive shelves.
About this task
Be sure to check the illustration arrow for the proper cable connector pull-tab orientation. The cable pull-
tab for the NS224 are up.
104
To Next Page
Loading...
