Return the failed part to NetApp, as described in the RMA instructions shipped with the kit. See the Part
Return & Replacements
page for further information.
= Replace an NVDIMM - ASA C400
:icons: font
:relative_path: ./asa-c-400/
:imagesdir: /tmp/d20231020-12297-25s5m0/source/./asa-c-250/../media/
You must replace the NVDIMM in the controller module when your system registers
that the flash lifetime is almost at an end or that the identified NVDIMM is not healthy
in general; failure to do so causes a system panic.
All other components in the system must be functioning properly; if not, you must contact technical
support.
You must replace the failed component with a replacement FRU component you received from your
provider.
== Step 1: Shut down the impaired controller
Shut down or take over the impaired controller using the appropriate procedure for your configuration.
179
To Next Page
Loading...
