EasyManua.ls Logo

NetApp AFF C400 - Page 58

NetApp AFF C400
111 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Find the High-Availability Configuration content for your version of ONTAP 9
b. After the giveback has been completed, confirm that the HA pair is healthy and that takeover is
possible:
storage failover show
The output from the storage failover show command should not include the System ID changed
on partner message.
7.
Verify that the disks were assigned correctly:
storage disk show -ownership
The disks belonging to the replacement controller should show the new system ID. In the following
example, the disks owned by node1 now show the new system ID, 1873775277:
node1> `storage disk show -ownership`
Disk Aggregate Home Owner DR Home Home ID Owner ID DR Home ID
Reserver Pool
----- ------ ----- ------ -------- ------- ------- -------
--------- ---
1.0.0 aggr0_1 node1 node1 - 1873775277 1873775277 -
1873775277 Pool0
1.0.1 aggr0_1 node1 node1 1873775277 1873775277 -
1873775277 Pool0
.
.
.
8.
If the system is in a MetroCluster configuration, monitor the status of the controller:
metrocluster node
show
The MetroCluster configuration takes a few minutes after the replacement to return to a normal state, at
which time each controller will show a configured state, with DR Mirroring enabled and a mode of normal.
The
metrocluster node show -fields node-systemid command output displays the old system
ID until the MetroCluster configuration returns to a normal state.
9. If the controller is in a MetroCluster configuration, depending on the MetroCluster state, verify that the DR
home ID field shows the original owner of the disk if the original owner is a controller on the disaster site.
This is required if both of the following are true:
The MetroCluster configuration is in a switchover state.
The replacement controller is the current owner of the disks on the disaster site.
Disk ownership changes during HA takeover and MetroCluster switchover in a four-node MetroCluster
configuration
10.
If your system is in a MetroCluster configuration, verify that each controller is configured:
metrocluster
node show - fields configuration-state
56

Related product manuals