EasyManuals Logo

NetApp AFF FAS8700 System Documentation

NetApp AFF FAS8700
1672 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1495 background imageLoading...
Page #1495 background image
NS224 shelves
Install and cable
Hot-add - NS224 shelves
You can hot-add an NS224 drive shelf after your HA pair meets certain requirements, and
after the preparation tasks applicable to your HA pair are completed.
Requirements for a hot-add
Your HA pair must meet certain requirements before hot-adding an NS224 drive shelf.
• Your platform model and version of ONTAP must support the NS224 shelf and drives you are hot-adding.
NetApp Hardware Universe
• You must have the correct number and type of cables to connect the shelf.
NetApp Hardware Universe
• Your HA pair must have enough available RoCE capable ports to support the number of shelves you are
hot-adding.
For each shelf you are hot-adding, you need a minimum of two RoCE capable ports on each controller.
These ports can be on board the controllers, on RoCE capable PCIe cards, a combination of both, or on
RoCE capable I/O modules, as supported by your platform model.
If your HA pair does not have enough available RoCE capable ports, and your platform model supports the
use of RoCE capable PCIe cards or I/O modules, you must have installed the additional cards or I/O
modules into the correct controller slots, as supported by your platform model.
NetApp Hardware Universe
Non-dedicated RoCE capable ports must be configured for storage use (not networking
use).
Prepare non-dedicated RoCE capable ports for a hot-add
• If you have an AFF A700 or ASA A700HA pair and you are hot-adding the initial NS224 drive shelf (no
NS224 drive shelf exists in your HA pair), you must have installed a core dump module (X9170A, NVMe
1TB SSD) in each controller to support core dumps (store core files).
Replace the caching module or add/replace a core dump module - AFF A700 and FAS9000
• Your HA pair must have less than the maximum number of shelves supported, by at least the number of
shelves you plan to hot-add.
You cannot have exceeded the maximum number of shelves supported by your HA pair after hot-adding
shelves.
NetApp Hardware Universe
1492

Other manuals for NetApp AFF FAS8700

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NetApp AFF FAS8700 and is the answer not in the manual?

NetApp AFF FAS8700 Specifications

General IconGeneral
BrandNetApp
ModelAFF FAS8700
CategoryStorage
LanguageEnglish

Related product manuals