If your system has… Then…
No network connection and is in
a MetroCluster IP configuration
a.
Press
n when prompted to restore the backup configuration.
b. Reboot the system when prompted by the system.
c. Wait for the iSCSI storage connections to connect.
You can proceed after you see the following messages:
date-and-time [node-
name:iscsi.session.stateChanged:notice]:
iSCSI session state is changed to
Connected for the target iSCSI-target
(type: dr_auxiliary, address: ip-
address).
date-and-time [node-
name:iscsi.session.stateChanged:notice]:
iSCSI session state is changed to
Connected for the target iSCSI-target
(type: dr_partner, address: ip-address).
date-and-time [node-
name:iscsi.session.stateChanged:notice]:
iSCSI session state is changed to
Connected for the target iSCSI-target
(type: dr_auxiliary, address: ip-
address).
date-and-time [node-
name:iscsi.session.stateChanged:notice]:
iSCSI session state is changed to
Connected for the target iSCSI-target
(type: dr_partner, address: ip-address).
d. Select the Update flash from backup config (sync flash)
option from the displayed menu.
If you are prompted to continue with the update, press
y.
4. Ensure that the environmental variables are set as expected:
a. Take the controller to the LOADER prompt.
b.
Check the environment variable settings with the
printenv command.
c. If an environment variable is not set as expected, modify it with the
setenvenvironment_variable_name changed_value command.
d.
Save your changes using the
saveenv command.
5. The next depends on your system configuration:
31
To Next Page
Loading...
