EasyManuals Logo

NetApp FAS User Manual

NetApp FAS
704 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #126 background imageLoading...
Page #126 background image
same model as the impaired chassis.
All other components in the system must be functioning properly; if not, you must contact technical support.
• You can use this procedure with all versions of ONTAP supported by your system.
• This procedure is written with the assumption that you are moving all drives and controller module or
modules to the new chassis, and that the chassis is a new component from NetApp.
• This procedure is disruptive. For a two-node cluster, you will have a complete service outage and a partial
outage in a multi-node cluster.
AFF FAS2600 chassis replacement video
Shut down the controllers - FAS2600
You must shut down the controller or controller in the chassis prior to moving them to the
new chassis.
About this task
• If you have a cluster with more than two controllers, it must be in quorum. If the cluster is not in quorum or
a healthy controller shows
false for eligibility and health, you must correct the issue before shutting down
the impaired controller; see the
Administration overview with the CLI.
• If AutoSupport is enabled, suppress automatic case creation by invoking an AutoSupport message:
system node autosupport invoke -node * -type all -message
MAINT=number_of_hours_downh
The following AutoSupport message suppresses automatic case creation for two hours: cluster1:*>
system node autosupport invoke -node * -type all -message MAINT=2h
Steps
1. If your system has two controller modules, disable the HA pair.
If your system is running
clustered ONTAP with…
Then…
Two controllers in the cluster
cluster ha modify -configured false storage failover
modify -node node0 -enabled false
More than two controllers in the
cluster
storage failover modify -node node0 -enabled false
2.
Halt the controller, pressing
y when you are prompted to confirm the halt: system node halt -node
node_name
The confirmation message looks like the following:
124

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NetApp FAS and is the answer not in the manual?

NetApp FAS Specifications

General IconGeneral
BrandNetApp
ModelFAS
CategoryDisk array system
LanguageEnglish

Related product manuals