NetApp FAS User Manual

If your system has… Then…
A network connection a.
Press
y when prompted to restore the backup configuration.
b.
Set the healthy controller to advanced privilege level:
set
-privilege advanced
c.
Run the restore backup command:
system node restore-
backup -node local -target-address
impaired_node_IP_address
d.
Return the controller to admin level:
set -privilege admin
e.
Press
y when prompted to use the restored configuration.
f.
Press
y when prompted to reboot the controller.
No network connection a.
Press
n when prompted to restore the backup configuration.
b. Reboot the system when prompted by the system.
c. Select the Update flash from backup config (sync flash) option
from the displayed menu.
If you are prompted to continue with the update, press
y.
4. Ensure that the environmental variables are set as expected:
a. Take the controller to the LOADER prompt.
b.
Check the environment variable settings with the
printenv command.
c.
If an environment variable is not set as expected, modify it with the
setenv environment-
variable-name changed-value
command.
d.
Save your changes using the
savenv command.
5. The next depends on your system configuration:
◦ If your system has onboard keymanager, NSE or NVE configured, go to
Restore OKM, NSE, and NVE
as needed
◦ If your system does not have onboard keymanager, NSE or NVE configured, complete the steps in this
section.
6.
From the LOADER prompt, enter the
boot_ontap command.
If you see… Then…
The login prompt Go to the next Step.
Waiting for giveback… a. Log into the partner controller.
b. Confirm the target controller is ready for giveback with the
storage failover show command.
7. Connect the console cable to the partner controller.
320

NetApp FAS Specifications

General

Brand	NetApp
Model	FAS
Category	Disk array system
Language	English