1. Use the following animation to set one or more drive shelf IDs:
Setting drive shelf IDs
2. Plug the power cords into the controller power supplies, and then connect them to power sources on
different circuits.
3. Make sure that your laptop has network discovery enabled.
See your laptop’s online help for more information.
4. Use the following animation to connect your laptop to the Management switch.
Connecting your laptop to the Management switch
5. Select an ONTAP icon listed to discover:
a. Open File Explorer.
b. Click network in the left pane.
c. Right click and select refresh.
d. Double-click either ONTAP icon and accept any certificates displayed on your screen.
XXXXX is the system serial number for the target node.
System Manager opens.
6. Use System Manager guided setup to configure your system using the data you collected in the NetApp
ONTAP Configuration Guide.
ONTAP Configuration Guide
7. Set up your account and download Active IQ Config Advisor:
a. Log in to your existing account or create an account.
NetApp Support Registration
432
To Next Page
Loading...
