cluster_B::> metrocluster show
Cluster Configuration State Mode
-------------------- ------------------- ---------
ÊLocal: cluster_B configured switchover
Remote: cluster_A configured waiting-for-switchback
The switchback operation is complete when the clusters are in the normal state.:
cluster_B::> metrocluster show
Cluster Configuration State Mode
-------------------- ------------------- ---------
ÊLocal: cluster_B configured normal
Remote: cluster_A configured normal
If a switchback is taking a long time to finish, you can check on the status of in-progress baselines by using
the
metrocluster config-replication resync-status show command.
6. Reestablish any SnapMirror or SnapVault configurations.
Step 8: Complete the replacement process
After you replace the part, you can return the failed part to NetApp, as described in the
RMA instructions shipped with the kit. Contact technical support at
NetApp Support, 888-
463-8277 (North America), 00-800-44-638277 (Europe), or +800-800-80-800
(Asia/Pacific) if you need the RMA number or additional help with the replacement
procedure.
Chassis
Overview of chassis replacement - FAS8300 and FAS8700
All other components in the system must be functioning properly; if not, you must contact
technical support.
• You can use this procedure with all versions of ONTAP supported by your system.
• This procedure is disruptive. For a two-controller cluster, you will have a complete service outage and a
partial outage in a multi-node cluster.
Shut down the controllers - FAS8300 and FAS8700
Option 1: Most configurations
You must shut down the controller or controller in the chassis prior to moving them to the
new chassis.
About this task
465
To Next Page
Loading...
Need help?
General
