FAS2600 System Documentation
Install and setup
Cluster configuration worksheet - FAS2600
You can use the worksheet to gather and record your site-specific IP addresses and other information required
when configuring an ONTAP cluster.
Cluster Configuration Worksheet
Start here: Choose your installation and setup experience
You can choose from different content formats to guide you through installing and setting
up your new storage system.
•
Quick steps
A printable PDF of step-by-step instructions with live links to additional content.
•
Video steps
Video step-by-step instructions.
Installation and setup PDF poster - FAS2600
You can use the PDF poster to install and set up your new system. The AFF FAS2600 Installation and Setup
Instructions
provides step-by-step instructions with live links to additional content.
Installation and setup video - FAS2600
The following video shows end-to-end software configuration for systems running ONTAP 9.2.
AFF FAS2600 Setup Video
Maintain
Boot media
Overview of boot media replacement - FAS2600
The boot media stores a primary and secondary set of system (boot image) files that the
system uses when it boots. Depending on your network configuration, you can perform
either a nondisruptive or disruptive replacement.
You must have a USB flash drive, formatted to FAT32, with the appropriate amount of storage to hold the
image_xxx.tgz file.
You also must copy the
image_xxx.tgz file to the USB flash drive for later use in this procedure.
•
The nondisruptive and disruptive methods for replacing a boot media both require you to restore the
var
file system:
96
To Next Page
Loading...
