Product Manual, TNSR 19.02
1.1.2 Netgate 6100 MAX Secure Router Manual
This Quick Start Guide covers the first time connection procedures for the Netgate 6100 MAX Secure Router and also
provides information needed to stay up and running.
Getting Started
Use the following steps to configure the TNSR Secure Router.
1. To configure the Network Interfaces and gaining access to the Internet, follow the instructions provided in the
Zero-to-Ping documentation.
Note: Not all steps in the Zero-to-Ping documentation will be necessary for every configuration scenario.
2. Once the Host OS is capable of reaching the Internet, check for updates (Updating TNSR) before proceeding.
This ensures the security and integrity of the router before TNSR interfaces are exposed to the Internet.
3. Finally, configure the TNSR instance to meet the specific use case. The topics are listed on the left column of
the TNSR Documentation site. There are also TNSR Configuration Example Recipes that might be of assistance
when configuring TNSR.
Input and Output Ports
Networking Ports
The WAN1 and WAN2 Combo-Ports are shared ports. Each has an RJ-45 port and an SFP port. Only the RJ-45 or the
SFP connector can be used each port.
Note: Each port, WAN1 and WAN2, is descrete and individual. It is possible to use the RJ-45 connector on one port
and the SFP connector on the other.
1.1. Netgate Appliances 13
To Next Page
Loading...