Product ManualXG-7100-1U
Selecting Switches from the drop-down will bring up the Switch page with four sections:
System
Fig. 1: Information on the Marvell 6000 switch
LAGGs
Ports
Information on switchport status and port names. If 802.1q is enabled, this section can also be used to specify the
native VLAN ID for each port. The Port VID defined will be used to tag inbound untagged traffic.
VLANs
Enable/Disable 802.1q VLAN mode. Configure VLAN access/trunk interfaces with 802.1q or configure port groups
with Port VLAN Mode.
1.2. XG-7100 Switch Overview 9
To Next Page
Loading...
