Security Gateway Manual XG-7100-1U
2.1.3 Switch Configuration Examples
Dedicated LAN switch
In this scenario, SFP+ port ix0 will be configured as the WAN interface. ETH1-8 will be configured as a LAN switch.
For this specific example, I’ll perform the WAN interface reassignment over console. Re-assigning the WAN can be
done from the webGUI as well.
This is what the default interface assignments look like on a XG-7100 without an addon NIC:
In this example, ix0 will be WAN, so select option 1 to re-assign WAN from lagg0.4090 to ix0:
No additional VLANs are needed for this, so enter n to continue.
Input ix0 as the new WAN interface name:
© Copyright 2020 Rubicon Communications LLC 36
To Next Page
Loading...
