Security Gateway Manual XG-7100-1U
At this point SFP+ port ix0 is now configured as the WAN interface. The LAN interface is still configured the same as
the default. Next, the switch will need to be updated so that ETH1 (previously WAN) acts the same as ETH2-8. This
will be done from the webGUI.
From the webGUI, pull up the Switch VLAN configuration under Interfaces -> Switches -> VLANs:
VLAN 4090 is no longer needed since WAN is dedicated to ix0 now. You can either select on the row containing
4090 to delete this entry, or click to remove port 1 as a member:
© Copyright 2020 Rubicon Communications LLC 38
To Next Page
Loading...
