Reference Guide for the Model MR314 Cable/DSL Wireless Router
Setting Up the Hardware 2-7
3.
After approximately 30 seconds, verify that:
a.
The TEST LED is not lit.
b.
The WIRELESS ON LED is lit.
c.
The LOCAL LNK/ACT LEDs are lit for any local ports that are connected.
d.
The INTERNET LNK LED is lit.
If a LNK or LNK/ACT LED is lit, a link has been established to the connected device.
4.
If a LOCAL port is connected to a 100 Mbps device, verify that the 100 LED is lit.
You are now ready to begin configuration of your network, as described in the following chapter.
To Next Page
Loading...
