Reference Guide for the Model MR314 Cable/DSL Wireless Router
4-6 Basic Configuration of the Router
9.
ClickonNexttogototheISPParametersscreen,showninFigure 4-5 below:
Figure 4-5. Browser-based Setup Wizard, third screen
This screen determines whether a login program will be run.
a.
If your service provider does not require a login program, leave Encapsulation as Ethernet
and proceed to Step 10.
b.
If your service provider uses PPP over Ethernet (PPPoE), select Encapsulation as PPPoE,
and enter these additional parameters:
• If your connection supports multiple ISPs, enter the Service Name of the one you use.
Otherwise leave Service Name blank.
• Enter the PPPoE login user name and password provided by your ISP. These fields are
case sensitive.
• If you wish to change the login timeout, enter a new value in seconds.
Proceed to Step 10.
c.
European users only: If your service provider uses Alcatel's ANT (ADSL Network
Termination) with PPTP as a login method, select Encapsulation as PPTP, and enter these
additional parameters:
• Enter the PPTP login user name and password provided by your ISP. These fields are
case sensitive.
• If you wish to change the login timeout, enter a new value in seconds.
To Next Page
Loading...
