NETGEAR N450 WNR2500 - Page 115

Advanced Settings
115
N450 Wireless Router WNR2500
3. (Optional) Control the volume of Internet traffic.
You can use either the traffic volume control feature or the connection time control feature
to do this.
• Select the T
raffic volume control by radio button and then select one of the
following options:
- No Limit. No restriction is applied when the traf
fic limit is reached.
- Download only.
The restriction is applied to incoming traffic only.
- Both Directions.
The restriction is applied to both incoming and outgoing traffic.
• Select the Connection time control radio button and enter the allowed hours in the
Monthly limit field.
4. (Optional) If your ISP charges for extra data volume when you make a new connection,
enter the extra data volume in MB in the Round up data volume for each connection by field.
5. In the
Traffic Counter section, set up the traffic counter to begin at a specific time and date
of each month.
If you want the traffic counter to start immediately, click the Restart Counter Now button.
6. In the
Traffic Control section, specify whether a warning message is issued before the
monthly traffic limit of MB or hours is reached.
By default, the value is 0 and no warning message is issued. You can select one of the
following to occur when the traf
fic limit is reached:
• The Internet LED blinks green or amber.
• The Internet connection is disconnected and disabled.
7. Click the Apply button.
Your changes are saved.
8. In the Internet
Traffic Statistics section, monitor the data traffic.
• T
o update the Traffic Statistics section, click the Refresh button.
• T
o display more information about the data traffic on your router and to change the
poll interval, click the Traffic Status button.