4
Network Settings
The router comes ready for WiFi, Ethernet, and USB connections.You can customize the router’s network settings.
NETGEAR recommends that you install the router and connect it to the Internet before you change its network settings.
This chapter includes the following sections:
• View or Change WAN Settings on page 49
• Set Up a Default DMZ Server on page 50
• Change the Router’s Device Name on page 51
• Change the LAN TCP/IP Settings on page 51
• Specify the IP Addresses That the Router Assigns on page 53
• Disable the DHCP Server Feature in the Router on page 55
• Manage Reserved LAN IP Addresses on page 55
• Use the WPS Wizard for WiFi Connections on page 57
• Specify Basic WiFi Settings on page 58
• Change the WiFi Password or Security Level on page 62
• Enable or Disable WiFi MU-MIMO on page 63
• Enable or Disable WiFi 160 MHz on page 63
• Enable a WiFi Video Network on page 64
• Set Up a Guest WiFi Network on page 65
• Enable a WiFi Video Network on page 64
• Control the WiFi Radios on page 67
• Set Up a WiFi Schedule on page 69
• Specify WPS Settings on page 70
• Use the Router as a Wireless Access Point on page 70
• Use the Router in Bridge Mode on page 72
48
To Next Page
Loading...
