Disable or Enable LED Blinking or Turn Off LEDs
The LEDs on the back panel of the router indicate activities and behavior.You can turn off the router LEDs
using the LED On/Off switch on the rear panel of the router.You can also log in to the router to disable or
enable LED blinking or turn off the LEDs. In addition, you can disable LED blinking for network
communications, or turn off all LEDs except the Power LED.
To disable LED blinking or turn off the LEDs using the router web interface:
1. Launch a web browser from a computer or mobile device that is connected to the network.
2. Enter http://www.routerlogin.net in the address field.
A login window opens.
3. Enter the router user name and password.
The user name is admin.The default password is password. The user name and password are
case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > LED Control Settings.
The LED Control Settings page displays.
5. Select an LED control setting:
• Enable blinking on Internet LED, LAN LED,Wireless LED and USB LED when data traffic is
detected. Allows standard LED behavior.This setting is enabled by default.
• Disable blinking on Internet LED, LAN LED,Wireless LED and USB LED when data traffic is
detected. Blinking is disabled when data traffic is detected.
• Turn off all LEDs except Power LED. All the LEDs, except the Power LED, are turned off.
For more information about LEDs, see LEDs and Buttons on the Top Panel on page 11.
6. Click the Apply button.
Your settings are saved.
Hardware Overview of the Router
17
Nighthawk X6S AC3000 Tri-Band WiFi Router Model R7900P
To Next Page
Loading...
