NETGEAR ProSafe GSM7224P - Show Ipv6 Access-Lists

Quality of Service (QoS) Commands
484
ProSafe Managed Switch
Note: You should be aware that the <out> option may or may not be
available, depending on the platform.
no ipv6 traffic-filter
This command removes an IPv6 ACL identified by <name> from the interface(s) in a given
direction.
Format no ipv6 traffic-filter <name> [vlan <vlan-id>] in [sequence
<1-4294967295>]
Modes
• Global Config
• Interface Config
show ipv6 access-lists
This command displays an IPv6 access list and all of the rules that are defined for the IPv6
ACL. Use the [name] parameter to identify a specific IPv6 ACL to display.
Format show ipv6 access-lists [name]
Mode
Format ipv6 traffic-filter <name> [vlan <vlan-id>] <in | out>[sequence
<1-4294967295>]
Modes
• Global Config
• Interface Config
Privileged EXEC
Term Definition
Rule Number
The ordered rule number identifier defined within the IPv6 ACL.
Action
The action associated with each rule. The possible values are Permit or Deny.
Match All
Indicates whether this access list applies to every packet. Possible values are True or
False.
Protocol
The protocol to filter for this rule.
Source IP
Address
The source IP address for this rule.
Source L4 Port
Keyword
The source port for this rule.
Destination IP
Address
The destination IP address for this rule.
Destination L4
Port Keyword
The destination port for this rule.