Reference Manual for the 108 Mbps Wireless Media Router WGT634U
Maintenance 7-5
April 2004, 202-10018-02
Viewing a List of Attached Devices
The Attached Devices menu contains a table of all IP devices that the router has discovered on the
local network. From the main menu of the browser interface, under the Maintenance heading,
select Attached Devices to view the table, shown below.
Figure 7-4: Attached Devices menu
For each device, the table shows the IP address, Device Name (if available), and Ethernet MAC
address. Note that if the router is rebooted, the table data is lost until the router rediscovers the
devices. To force the router to look for attached devices, click the Refresh button.
Upgrading the Router Software
The routing software of the WGT634U Wireless Media Router is stored in FLASH memory, and
can be upgraded as new software is released by NETGEAR. You can start the router firmware
upgrade in one of two ways:
• Using the Firmware Assistant Upgrade prompt that appears when you first log in to the router
• Using the Maintenance > Router Upgrade menu
Note: Product support information and updates are available on the NETGEAR, Inc.
Web site at http://kbserver.netgear.com/products/WGT634U.asp.
To Next Page
Loading...
