NetModule NB2800 - Page 2

www.netmodule.com 8/7/2017 © NetModule AG | Errors reserved
To remove the SIM cards, you will need to push them
again in the same manner. The SIM cards will then pop
out and can be pulled out.
4
SIM cover
Removing the SIM cover: Loosen both screws and flip
over the SIM cover until the SIM card holder is
completely free.
Please close the cover after inserting a SIM card and
tighten the screws again.
5
Reset button
The reset button is accessible through a small hole in the
right of the SIM card slots. Press at least 3 seconds for
reboot and at least 10 second for a factory reset. The
start of the factory reset is confirmed by all LEDs lighting
up for a second. The button must be released then
again.
6
Ethernet
Connect your router by using the ETH 1 with your
computer to start the configuration. Your router is
configured as a DHCP server by default and has the IP
address 192.168.1.1. Open this IP in your browser to
reach the WEB-GUI.
7
LTE
FAKRA connectors for MIMO LTE antennas. The left port
is always the main port.
8
WLAN
FAKRA connectors for MIMO WLAN antennas. The left
port is always the main port.
9
Power and
Ignition
Sense
The router can be powered with an external source with
the nominal input voltages 12
VDC
, 24
VDC
, 36
VDC
and 48
VDC
.
For power, use the pins 1 (V
GND
) and 2 (V+). For ignition
sense, use pin 3 (IGN).
10
Extension
port cover
Connector for extensions. Please find detailed
information in the router manual.