Test the functionality of your irrigation system with your
current controller first. If it does not work, please make
sure it is repaired before installing the Sprite.
Note: If you are not sure about the condition of your sprinkler system,
you might want to check whether there are shorted zones or open zones.
You just need to use a multimeter to measure the resistance between the
common wire and each zone. The normal reading would be 20-60 Ohms.
If the reading is less than 10 Ohms then you might have a shorted circuit
in the solenoid and if it is larger than 80 Ohms you might have an open
circuit. Please contact us or irrigation professionals for additional support.
-2-
Unplug the power of your current controller.
Take a photo of the wiring in your old
controller. When you are wiring Sprite,
this photo can be the reference.
Remove your current controller.
Preparation
1
2
3
4
To Next Page
Loading...