Remove the helmet and
components from the
case. Take the velcro
strips from the adhesive
paper and apply onto the
inside of the helmet as
shown in the diagram.
Apply the sponges or
foam headpiece onto the
velcro so the unit is tted
during use.
Do not place any velcro
on the clear plastic
inside the helmet.
Fitting Guide
Connect the helmet with
the controller, connect the
controller with the rst
power adapter.
Turning on the Device
Thank you for purchasing the
Neuradiant 1070.
First
Adapter
Second
Adapter
Connect the controller with
the second power adapter.
After connecting the cables,
you can turn on the device
via the button on the top
right.
Sponges Foam
Headpiece
Velcro
Bottom View
To Next Page
Need help?
General
