90
°
90
°
MOBILE
2
The sensor tip should touch the skin
above your left eyebrow with a little
pressure.
Bend the arm before putting
on headset for best t.
Brainwave Sensor Placement
Check these areas to get the best fit
Turn on the headset. The blue LED will turn on.
You can pair the device at anytime.
Once the headset is paired, visit MWM2.neurosky.com. QR code on page one.
Mac OS X Setup
Proceed with pairing procedure.
Open System Preferences
If asked to “Select Device
Type”choose Any Device
Enter 0000 if prompted for
passkey
Click Bluetooth icon
Click Passkey Options. Set
to “Use a specific passkey”
Use the Default setting if
asked about services
Click on the “ + “ icon
Select MindWave Mobile
and click Next
Click Close to complete
pairing
For Mac OS X 10.8:
For Mac OS X 10.9 ~ 10.13:
Open System Preferences
Select MindWave Mobile
Click Bluetooth icon
Note Ensure that you are running OS X version 10.8 or later with an Intel processor, and that you have Administrator
Privileges. Also ensure that all antivirus and firewall programs are disabled during installation.
Click Pair to complete pairing (Ensure that your Bluetooth is turned on)
iOS Setup
Turn on the headset. The
blue LED
will turn on.
Visit MWM2.neurosky.com. You can use the QR codeon the first page of this guide to easily navigate there.
Go to the NeuroSky Store at http://store.neurosky.com/collections/apps/ios
to download apps.
*Read app descriptions to ensure they are compatible with MindWave Mobile 2 and your operating system.
Follow the instructions on that page to download, install and run the "MindWave Mobile Tutorial" app,
then follow instructions from the app to furtherconfigure your headset.
Headset will be OFF
The LED will be OFF
Headset will be ON
Insert One (1)
AAA Battery
Rotate the Sensor
Arm Down
Power Located Here
When the headset is powered on
the LED will light up blue.
You can pair the headset at any
time while it is powered on.
Before You Start
LED
Quick Start Guide
The Headset
How to Wear the MindWave Mobile 2 Headset
The headset should rest on the head as shown with the sensor tip touching the
forehead, the ear loop behind the ear and the clip attached.
MindWave Mobile 2 Headset Basics
Ear Loop
Sensor Arm & Tip
Rotate Sensor Clip on Ear Sensor on Left Behind Ear
Ear Clip
&
You may now download other brainwave-powered apps from the NeuroSky App Store,
store.neurosky.com/collections/apps
Follow the instructions on that page to download, install and run the "MindWave Mobile Tutorial" app.
Then follow instructions from the app to further configure your headset.
Adjustable
Head Band
IMPORTANT
You must properly set up each
MindWave Mobile 2 by going to this address:
MWM2.neurosky.com
4
5
1
2
3
4
1
2
3
a
a
b
b
c
f
ih
c
d
d
e
g
*The pairing will show as "Connected" for a few seconds, and then change itself back to "Not Connected".
Don't worry, whenever you start a MindWave Mobile 2 app, it will show as "Connected" again.
To Next Page
General