Safety instructions
7.14 The battery must be covered with insulating material if any maintenance work is done in
its vicinity.
No tools may be laid down on the battery.
In the case of electrically driven earthmoving machinery, the electrical systems and
where
necessary the mobile connection lines must be switched off and secured against
inadvertent or
unauthorised switching on.
Protective devices of moving machine parts must not be opened or removed unless the
drive has
been stopped and secured against unauthorised starting.
Protective devices are, for example, motor compartment flaps, doors, guards,
housings.
7.17
7.18
7.19
7.20
7.21
7.22
7.23
7.24
8
8.1
8.2
8.3
On completion of assembly, maintenance or repair work, all protective devices must be
correctly
mounted again.
Welding work on load-bearing parts of earthmoving machinery, e.g. lattice booms,
lifting cranks,
must be carried out in accordance with the recognised rules of welding technology.
No welding or drilling may be carried out on roll-over, tipp-over or fall-over protective
structures
(ROPS, TOPS, FOPS).
Modifications, e.g. welding on the hydraulic or compressed air system, must not be
undertaken
except with the authorisation of the manufacturer.
The control pressure, dynamic pressure and internal tank pressure must be
reduced before
starting work on the hydraulic system.
Only those hoses and lines prescribed by the manufacturer may be
used.
Hydraulic hoses and lines must be skilfully laid and
installed.
Smoking and the use of open flames are forbidden during
refuelling.
Recovery, towing, transport
The recovery and towing of earthmoving machinery must be done with adequately
dimensioned
towing devices only.
The towing points or blocks prescribed by the manufacturer, e.g. lugs, hooks, must
be used.
The towing vehicle must be driven slowly. All persons must keep out of the range
of towing
devices.
7.15
7.16
9707672_User manual_en
- A 11 -
To Next Page
Loading...