Introduction
Make sure you have sufficient knowledge of the
working area.
- Location of supply lines (electricity, water, gas,
telephone,
etc.)
- Load bearing capacity of ground
* Before working in the vicinity of supply lines:
Contact the respective authority (e.g. gas,
electricity,
etc.)
Your responsibilty!
Together determine the appropriate safety measures.
Only do work together with a signaller (better
visibility).
ATTENTION: Damaging a cable or pipe can
endanger everyone present and the
environment.
*
* Never dig under the vehicle. When excavating in
or near excavated areas, ensure that the walls
are
well supported!
CAUTION: Risk of collapse
* Working inside buildings
- Watch height of ceiling
- Check load bearing capacity of floor
- Ensure a flow of fresh air because of exhaust
fumes
Never drive longer distances with the working
equipment (bucket, grab, etc.) fully raised.
Lowering
the working equipment provides improved
visibility
and better weight distribution.
Never drive across a slope on an incline.
Unauthorized persons are not allowed to start
or
operate the excavator.
*
*
*
9707672_User manual_en
- 15 -
To Next Page
Loading...