New England Arbors VA94436 User Manual

Check Box for These Contents
In the event of missing or defective parts please call our customer service dept. at 1 800 282 9346
(Mon. to Fri.8:00 AM to 4:00 PM EST) or UK Tel:(44) 2038 687160 - (Mon. to Fri. 1:00 PM to 10:00 PM GMT).
Tools You Will Need
• Tape Measure
• Level
• Sledge Hammer
• Cordless Drill with #2 Phillips Bit
Purchased Separately
• Lamp Fixture
General Information
• Read Instructions through carefully before beginning assembly.
• When handling components, place on a non-abrasive surface
(i.e. shipping box) to avoid scratching.
• We recommend an area approx 10’x 8’ (3m x 2.4m) for unobstructed handling.
Important Note:
• Please refer to local codes before installing outdoor lighting. UF-rated cable should be used for underground
wiring and all materials should be approved by the Underwriter’s Laborator (UL). New England Arbors
assumes no liability for errors, ommissionsm or the outcome of any project.
4x4 Lamp Post with EZ Mount
Please read through before starting assembly.
ASSEMBLY IN ST RUC TIONS
1
Ver 1.2-012218
3
Not to Scale
1
2
4
www.newenglandarbors.com
www.newenglandarbors.co.uk
73 7/8 in
(188 cm)
24 in
(61 cm)
24 in
(61 cm)
3 in (7.6 cm)
Diameter
1. Lamp Post (1) - 4” x 4” x 72” (10x10x183cm) - 10273
2. EZ Mount Anchor Assembly (1) - 1 5/8“ Diameter x 48” (4cm Diameter x 122cm) - 11102
3. Post Cap (1) - 10272
4. 5/8“ (16mm) Self-Tapping Screw (1) - 20016
5. Tube of Vinyl Weld (1) - 20000
5

New England Arbors VA94436 Specifications

General

Brand	New England Arbors
Model	VA94436
Category	Outdoor Light
Language	English

Summary

STEP ONE EZ Mount Anchor Installation

Remove Top Outer Gear

Temporarily remove the top outer gear to prevent damage during installation.

Ensure Pipe is Straight and Plumb

Use a level to check the pipe's alignment every few swings during driving.

Drive Pipe to Correct Height

Drive the pipe until its top is approximately 24 inches above ground.

Note Measurement for Screw Location

Record the 2 3/8 inch measurement for future screw placement.

STEP TWO EZ Mount Anchor Adjustment

Adjustable Leveling Gears

Top and bottom outer gears adjust to compensate for crooked pipes and provide a level surface.

Level Anchor Gears

Unlock and adjust outer gears for a level surface before proceeding.

STEP THREE Lamp Post Installation

Mount Lamp Post onto Anchor

Slide the lamp post over the anchor assembly. Thread electrical cable if applicable.

Secure Lamp Post with Screw

Fasten the lamp post to the bottom outer gear using a self-tapping screw at the noted position.

STEP FOUR Post Cap Installation

Thread Electrical Cable Through Post Cap

Route the electrical cable through the post cap opening for hardwired fixtures.

Apply Vinyl Weld to Post Cap

Apply vinyl weld to the inside walls of the post cap before attaching it to the lamp post.

Install Lamp Fixture

Follow the specific instructions provided with the lamp fixture assembly.