New Holland TD 95D - Front Axle and Transmission Lubrication

SECTION 4 -- LUBRICATION AND MAINTENANCE
4--21
OPERATION 33
FINAL REDUCTION GEARS -- Fig. 41
Check the oil level as follows :
-- Park the tractor on a level surface.
-- Remove the plug (1). Some oil should flow out of
the plug hole. If necessary, top up via same plug
hole until the oil overflows.
1
TRE0016A
41
OPERATION 34
DRY AIR FILTER, EXTERNAL CARTRIDGE
-- Fig. 42
Remove the cover, take out external cartridge (1)
and clean as described in operation 9, on page 4--9
of this section.
42
OPERATION 35
TRANSMISSION AND HYDRAULIC LIFT --
Fig. 43
With the tractor on a level surface, the engine shut
off and the hydraulic lift linkage fully lowered, check
that the oil level reaches the ”MAX” mark on the
combined filler plug / dipstick (1).
If necessary, add oil through the fill point and replace
the plug.
NOTE: For oil grades, see the lubrication charts
beginning on pages 4--41.
1
TRE0015A
43