SECTION 9 -- 1
ST
50 HOUR SERVICE SHEETS
9--1
Inspections and operations carried out
Tractor model Serial No.:............................. ...................................
Customer’s signature Date Dealer’s signature Date
OPERATIONAL INSPECTIONS
1. Lightsandinternalinstrumentation ........
2. Oilandliquidleaks .....................
3. Maximum and minimum idling speeds
and engine cut--off ......................
4. Powertake--offandbrakes...............
5. Hydraulic system:
Draftcontrolworking ....................
Positioncontrolworking .................
Auxiliarycontrolvalves ..................
Controlvalvesintake....................
Systempressure .......................
FUNCTIONAL INSPECTIONS
1. Engine, accelerator and speed governor . . .
2. Gearbox ..............................
3. Steering operates correctly ..............
4. Differential lock and 4WD engage/disengage
5. Brake operation ........................
6. Optional equipment and accessories .....
INSPECTIONS OF SAFETY EQUIPMENT
1. Safety belts (optional) ...................
2. Torque cab mounting nuts ...............
3. Power take--off electrical safety
devices engaged .......................
4. Handbrake operation and adjustment .....
5. Safety guards and covers ................
NON FUNCTIONAL INSPECTIONS/OPERATIONS
1. T yr e pressures and conditi on
2. Air filter cartridge and hoses ...............
3. Cooling system hoses ....................
4.
Specific gravity and level of coolant
(specific gravity 1,071 to 1,083 at 16
o
C) ...
5.
Replace fuel f i lter, clean sediment f ilter
and purge air from fuel system
.............
6.
Drive belts for cooling fan, alternator and
air conditioning compressor
...............
7.
Change engine oil and filter ...............
8.
Change hydraulic oil filter .................
9.
Check oil level in rear transmission housing
10. Grease all lubric ation fittings and
lubricate joints
............................
11.
Tighten wheel disc nuts ....................
12.
Tighten wheel rim nuts ....................
13.
Tighten bolts on front ballast ..............
14.
Front wheel toe --in and steering stops .....
15.
Battery leads and relative fittings ..........
16.
Windscreen wiper, washer bottle level .....
17.
Cab air filter clean ........................
18. Seat operation .........................
19. Exhaust pipe mounting
40 Nm (4,1 kgm) (29.7 ft.lbs)
..............
INSPECTIONS AND/OR OPERATIONS TO BE CARRIED OUT -- Dealer’s Copy
To Next Page
Loading...
