4 SECTION 18 − CLUTCH − CHAPTER 1
603.54.471.00 − 11 − 2004
LONGITUDINAL SECTION OF CLUTCH VALEO
1
a Main clutch with driven disc made of organic material..
b Main clutch with driven disc made of cerametallic..
C
2
Bolts securing clutch casing to the engine.
C
3
Fork lever retaining bolts.
C
6
Nuts for sleeve studs.
D Nominal distance of lever (3) from clutch contact sur-.
face on flywheel (mod. TD60D, TD70D, TD80D and
TD90D, 11”/11” clutch 98 mm (3.8583 in.) − mod.
TD95D 12”/12” clutch 103 mm (4.0551 in.)).
D
1
Nominal distance of lever (2) from clutch contact sur-
face on flywheel (mod. TD60D, TD70D, TD80D and
TD90D, 11”/11” clutch 123 mm (4.8425 in.) − mod.
TD95D 12”/12” clutch 137 mm (5.3937 in.)).
L
1
Clearance between PTO release lever and related
thrust bearing 2 mm (0.0787 in.).
L
2
Clearance between main clutch release lever and re-
lated thrust bearing 2.5 mm (0.0984 in.).
1. Belleville spring.
2. PTO clutch release lever.
3. Main clutch release lever.
4. Main clutch release sleeve, complete with thrust
bearings.
5. PTO clutch release sleeve, complete with thrust
bearings.
6. Power take−off clutch release lever adjustment tie
rod.
7. Power take−off clutch release lever stop nut.
8. Power take−off clutch plate.
9. Main transmission clutch plate.
10. Bearing on flywheel.
11. PTO clutch release sleeve control fork.
12. Main clutch release sleeve control fork.
13. Main clutch release lever adjuster lever.
14. Main clutch release lever adjuster screw.
15. Main clutch release lever adjuster nut.
WARNING: When refitting the clutch, check that the
clutch plates are positioned as in the drawing.
NOTE: When refitting, carefully clean and degrease
the mating surfaces X and apply sealing compound.
To Next Page
Loading...
