6 SECTION 18 − CLUTCH − CHAPTER 1
603.54.471.00 − 11 − 2004
CLUTCH
Removal−Refitting (Operation 18 110 10)
To access the clutch it is necessary to separate the
engine complete with the front axle from the tran-
smission.
DANGER
Lift and handle all heavy parts using suitable lifting
equipment.
Make sure that assemblies or parts are supported by
means of suitable slings and hooks. Check that no
one is in the vicinity of the load to be lifted.
ATTENTION
Always use suitable tools to align holes. NEVER
USE FINGERS OR HANDS.
Proceed as follows:
1. Disconnect the battery negative cable.
2. Drain off the oil from the gearbox/transmission
casing.
1
25621
2
1
3. Drain off the coolant from the engine cooling sys-
tem.
4. Disconnect two flexible houses from the power
steering control cylinder and drain off the oil from
the steering system.
5. Remove the front ballast (1).
TRE0159A
3
To Next Page
Loading...
