New Holland TD60D - Drive Lines Specifications

1
SECTION 23 -- DRIVE LINES -- CHAPTER 1
603.54.471.00 -- 11 -- 2004
SECTION 23 -- DRIVE LINES
Chapter 1 -- Drive Lines
CONTENTS
Section Description Page
23 000 Main specification 1.............................................................
Torque settings and Tools 2......................................................
Cross--Sectional views 3.........................................................
23 101 26 T ransmission shafts and guard (Disassembly -- Assembly) 4..........................
23 101 40 Drive gear housing (Removal -- Installation) 5.......................................
23 101 42 Drive gear housing removed (Disassembly -- Assembly) 7............................
MAIN SPECIFICATION
Reduction ratio ..........................................
34/24x24/34= 1 to 1
Relayleverpadwidth ..................................... mm
(in.)
7.978 -- 8.000
(0.3141 -- 0.3150)
Pad seat width in driven gear .............................. mm
(in.)
8.280 -- 8.370
(0.3260 -- 0.3295)
Padclearanceinseat ..................................... mm
(in.)
0.280 -- 0.460
(0.0110 -- 0.315)
Relayleverpivotdiameter ................................. mm
(in.)
15.973 -- 16.000
(0.6289 -- 0.6299)
Pivot housing bore in casing ............................... mm
(in.)
16.016 -- 16.059
(0.6305 -- 0.6322)
Pivot clearance in housing ................................. mm
(in.)
0.016 -- 0.086
(0.0006 -- 0.0124)
Relay lever detent spring length
--Free .................................................. mm
(in.)
130
(5.1181)
-- Under 178.2 to 197.8 N (40 to 44 lb ) ...................... mm
(in.)
142.5
(5.6102)
MAIN SPECIFICATION OF DRIVE SHAFT
Front drive sleeve adjustment
see page 4
Frontdrivesleeveshimthickness........................... mm
(in.)
2.2.--2.5--2.8--3--3.3--3.7--4--4.3
(0.0866--0.0984--0.1102--0.1181--
0.1299--0.1457--0.1575--0.1693)