New Holland TD60D - Installing the Rear Cover with Seal, and Engine Flywheel

71
SECTION 10 -- ENGINE -- CHAPTER 1
603.54.471.00 -- 11 -- 2004
117
INSTALLING THE REAR COVER WITH SEAL,
AND ENGINE FLYWHEEL
(Disassembly operation 62)
Proceed as follows:
— Fit the rear oil seal carrier (3) with the outer seal.
T ighten retaining bolts (2) to the torque specified
on page 24. Using a feeler gauge (1), check that
the crankshaft flange is coaxial with the carrier.
24752
1
2
3
118
— Fit the inner rear oil seal using installer and hand
grip 50139 (1).
24761
1
119
— Fit the flywheel and tighten the retaining bolts (1)
to a torque of 40 Nm (29.5025 ft lb).
24762
1
120
— Using tool 380000304 (1), tighten each flywheel
bolt (2) through a further 60°.
24763
1
2