71
CHAPTER 6
6.
Maintenance
6.1 Introduction
Module specific calibration can be found in the module's manual. There is no
calibration on the main frame. Do not attempt to remove the cover.
6.2 Fuse Replacement
The fuses are accessible on the back panel of the 6000. Before replacing a fuse, turn
power off and disconnect the line cord. Use only the fuses indicated below.
Line Voltage
Fuse Replacement
90-110 VAC 2.5 Amp, 3 AG, Slo-Blo, 250V
108-132 VAC 2.5 Amp, 3 AG, Slo-Blo, 250V
198-242 VAC 1.25 Amp, 3 AG, Slo-Blo, 250V
216-250 VAC 1.25 Amp, 3 AG, Slo-Blo, 250V
6.3 Cleaning
Use mild soap solution on a damp but not wet cloth. Disconnect AC power before
cleaning.
To Next Page
Loading...
