Chapter 8 Error Messages 95
Error Code
Explanation
E-211
<PROGRAM DATA> will not convert to a
character value.
E-212
<PROGRAM DATA> will not convert to a byte
array pointer.
E-213
<PROGRAM DATA> is incorrect block data
length.
E-214
<PROGRAM DATA> length exceeds maximum.
E-216
Present configuration has changed from last stored
configuration.
E-217
Attempted to recall a bin from a unsaved position.
E-301
A <RESPONSE MESSAGE> was ready, but
controller failed to read it. (Query error).
E-302
6000 is talker, but controller didn't read entire
message.
E-303
Input buffer overflow
E-304
Output buffer overflow
E-305
Parser buffer overflow
E-402
Sensor open disabled output.
E-403
TEC module open disabled output.
E-404
TEC Current limit disabled output.
E-405
TEC Voltage limit disabled output.
E-406
TEC resistance/reference limit disabled output
E-407
TEC high temperature limit disabled output.
E-409
Sensor change disabled output.
E-410
TEC out of tolerance disabled output.
E-411
TEC control error disabled output.
E-412
Analog section status is all 1's or all 0's (power
down).
E-413
Serial EPROM checksum error.
E-415
Sensor short disabled output.
E-416
Incorrect Configuration for Calibration Sequence to
start.
E-417
TEC output must be on to begin calibration.
E-418
TEC C1, C2, or C3 constants are bad, all set to
default values.
E-431
TEC link condition forced output on
E-432
TEC link condition forced output off
E-433
Attempt to select non-TEC channel for TEC mode.
E-501
Laser interlock disabled output.
E-502
Laser hard current limit disabled output
E-503
Laser open circuit disabled output.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
