96 Chapter 8 Error Messages
Error Code
Explanation
E-504
Laser current limit disabled output.
E-505
Laser voltage limit disabled output.
E-506
Laser photodiode current limit disabled output
E-507
Laser photodiode power limit disabled output.
E-508
TEC link disabled laser.
E-509
Laser short circuit disabled output
E-510
Laser out of tolerance disabled output.
E-511
Laser control error disabled output.
E-512
Analog section status is all 1's or 0's (power down).
E-513
Serial EPROM checksum error.
E-514
Laser mode change disabled output
E-515
Laser bandwidth change disabled output
E-516
Incorrect Configuration for Calibration Sequence to
start.
E-517
Calibration for Laser Diode current must have the
output on to start.
E-518
Calibration for the Monitor Diode must have the
output on and the sensitivity set to zero to start.
E-519
Setting a measurement is only valid during the
calibration phase for that measurement. User has
tried to calibrate a measurement without first
entering the required calibration mode.
E-520
User cannot change the Laser Current set point
while operating in a calibration mode for another
measurement.
E-531
Laser link condition forced output on
E-532
Laser link condition forced output off
E-533
Attempted to select non-laser channel for laser
operation.
E-900
Calculation Error shutdown output
E-901
System over temperature shutdown all outputs
E-902
Front laser enable panel key lock in off position,
shutdown all laser outputs
E-903
Loading of a saved bin shutdown module output
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
