ESP302 Controller Start-Up Manual
23 A1270B1 - EDH0411En1021 – 02/20
3.7.5 Testing your ESP302-PC Connection and Communication
To check if the ESP302 communicates with to the host computer, send a ping message
from the computer to the ESP302. This is done through the Windows menu: Start-
>Run->, then type: ping + IP address of the ESP302. See the example below for the IP
address 192.168.254.254:
If the ESP302 is connected and communicates properly, it replies in the terminal
window that appears after clicking on the OK button:
If the ESP302 controller is not communicating, the window displays that the time delay
of the request is exceeded. Ensure that the correct cable and IP addresses are set
properly.
To Next Page
Loading...
