7
About The Meter
MENU Button
In the run mode, press the MENU button to terminate the current measuring process and enter
you into the configuration mode.
In the configuration mode, press the MENU button to store changes in the non-volatile memory
and then advance you to the next menu item.
RESET Button
If you hard reset or power off/on the meter, it shows "RST" followed by "RTD".
In the run mode, press the RESET button to reset the setpoints and display "SP.RS". If display
shows peak value, press the RESET button to reset peak value. Display shows "PK.RS".
In the configuration mode, press the RESET button once to review the previous menu. Pressing
the RESET button twice results in a hard reset and returns you to the run mode.
2
To Next Page
Loading...
