3.45 EDH0162En1040 – 06/99
MM4005 ED — Display program error
Usage IMM PGM MIP
Syntax EDnn
Parameters
Description nn
[int] — Enable/disable code.
Range nn — 0 to 1.
Units nn
— None.
Defaults nn Missing: Error C.
Out of range: Error C.
Floating point: Error C.
Description This command activates the program execution error display utility. If nn
is set to 1, the program execution will stop every time an error is encoun-
tered and the following message will be displayed on line 5 of the display:
“Program aborted by error: * ” where “*” represents the ASCII error code.
On line 6, the last function key will be defined as QUIT and the program will
resume execution after pressing this key.
Setting
nn to zero disables the program execution error display utility. This
is the default mode of operation. Any error encountered will stop and ter-
minate the program. To determine the error causing the problem use the
TB or TE commands.
Returns None.
Errors C — Parameter out of limits.
Rel. Commands TB — Read error message.
TE — Read error code.
Example ED1 | Activate program execution error display utility.
3EX | Start executing program #3.
… |
… |
… |
ED0 |
Disable program execution error display utility.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
