XPS-Q8 Controller Appendix
21.0 Appendix C: Power Inhibit Connector
Figure 65: Inhibition connector.
This connector is provided for the wiring of a remote STOP ALL switch.
It has the same effect as the front panel STOP ALL button.
Inhibition input is a standard TTL input.
Inhibition (Pin #2), must always be connected to GND during normal controller
operation.
An open circuit is equivalent to pressing STOP ALL on the front panel. Wire the switch
contacts normally closed.
NOTE
Connecting more than one switch is not recommended on this input.
209 XPSDocumentation V1.4.x (EDH0301En1060 — 10/17)
To Next Page
Loading...
