XPS-Q8 Controller User’s Manual
NOTE
To avoid conflict with the REMOTE Ethernet plug, the IP address must be
different from 192.168.254…
NOTE
For the majority of Networks, the setting above for the Subnet Mask will work.
However, for larger networks (200 computers or more), the Subnet Mask address
must be verified with the IT department. In most cases and for larger networks,
the Subnet Mask is set to 255.255.0.0.
Once the appropriate addresses for the Static IP configuration are set, click on SET and
the following screen appears:
Go to the TERMINAL window, and double click on Reboot function, then press the
Execute button:
Wait for the end of the boot sequence. There is an initial beep a few seconds after power
on and a second beep when the controller has finished booting. The time between the
first beep and the second beep is approx. 12-18 seconds.
Connect the CAT-5 network cable (black) to the HOST connector of the XPS controller
and to your network.
After restarting the controller and restoring your PC’s Ethernet card default
configuration, open the Internet browser and connect using your given Static IP address.
If you don’t want to connect directly to the Corporate Network using the Dynamic IP
Configuration, skip to section 3.7: “Connecting the Stages“.
XPSDocumentation V1.4.x (EDH0301En1060 — 10/17) 20
To Next Page
Loading...
