Newport XPS-Q8 - Page 60

XPS-Q8 Controller Software Tools
This is an example of a system.ini file with one XY gantry:
[GROUPS]
SingleAxisInUse =
SpindleInUse =
XYInUse = MyXYGantry
XYZInUse =
MultipleAxesInUse =
[MyXYGantry]
PositionerInUse = X, Y
InitializationAndHomeSearchSequence = YThenX
XMappingFileName =
YMappingFileName =
;--- Gantry Force Ratio parameters
YOffsetForForceRatio = 0
PrimaryYForceRatio = 0
SecondaryYForceRatio = 0
[MyXYGantry.X]
PlugNumber = 1
StageName = IMS600LM
;---- Secondary positioner (X2)
SecondaryPlugNumber = 4
SecondaryStageName = IMS600LM
SecondaryPositionerGantryEndReferencingPosition = 10.2243
SecondaryPositionerGantryEndReferencingTolerance = 0.1
SecondaryPositionerGantryOffsetAfterInitialization = 7.47
[MyXYGantry.Y]
PlugNumber = 3
StageName = IMS400LM
XPSDocumentation V1.4.x (EDH0301En1060 — 10/17) 48