Need help?Do you have a question about the NEXT pool ABRIBLUE IMM'Ax and is the answer not in the manual?
General| Brand | NEXT pool |
|---|---|
| Model | ABRIBLUE IMM'Ax |
| Category | Lighting Equipment |
| Language | English |
Details on power supply, protection, and cable routing requirements.
Instructions for the 230 V power supply to the electric box.
Requirements for circuit breaker and ground fault circuit breaker.
Guidance on preparing sheaths for different voltage cables.
Requirements for concrete belts and overflow planning.
Specifications for creating a concrete belt for roller stabilization.
Planning for pool water level control via an overflow.
Recommendations for skimmer placement to facilitate cover movement.
Instructions on trench sizing and squaring checks for roller installation.
Table and method for determining the correct trench width.
Method for ensuring the roller is placed perpendicular to the pool lengths.
Guidelines for handling and transporting the pool cover roller.
Procedures for checking goods, reporting damages, and inventory.
List of components included in the roller container.
List of tools required for assembling the roller.
Detailed steps for drilling walls, assembling shaft, and installing the roller.
Instructions for drilling holes for roller flange fixtures.
Steps to assemble the motorised tube with flanges and motor.
Procedure for sliding the bearing shaft and lowering the roller into the pool.
Guidance on positioning sliders and beam boxes for cover support.
Steps for installing the partition wall and beam components.
Instructions for assembling the duckboard walkway and connections.
Method for transferring and positioning cover slats in the pool water.
Steps for clipping cover slats together to form packets.
Verifying required gaps between slats, apron, and pool edges.
Instructions for centering and assembling stair covers.
Guidance on placing safety systems for different cover models.
Procedures for fixing female loops and bracket supports for anti-lifting.
Steps for installing harpoons, triggers, and securing the Coverlock system.
Method for attaching the cover apron to the roller shaft.
Details on the PLC control box, its connections, and adjustments.
Wiring diagrams and instructions for connecting the PLC box.
Step-by-step guide for connecting power and motor wires to the PLC box.
Instructions for wiring the key switch for cover control.
Guidance on using and wiring the connection box for motors and sensors.
Procedure for setting the open and closed limits of the cover.
Details on the non-PLC control box, its connections, and adjustments.
Wiring diagrams and instructions for connecting the non-PLC box.
Step-by-step guide for connecting power and motor wires to the non-PLC box.
Instructions for wiring the key switch for cover control.
Guidance on using and wiring the connection box for motors and sensors.
Procedure for setting the open and closed limits of the cover.
Steps to disconnect the roller mechanism from the motor.
Guidance on positioning and fixing sensors and counterweights.
Wiring diagrams and instructions for connecting the motor and sensors.
Step-by-step guide for connecting motor, sensors, and key switch.
Instructions for wiring the key switch for cover control.
Guidance on using and wiring the connection box for motors and sensors.
Procedure for testing the cover's open and closed position limits.
Steps to disconnect the roller mechanism from the motor.
Instructions for installing an anti-bending console for cover support.
Procedures for fixing flanges, sliders, and beam boxes to the pool edge.
Steps for attaching fixing plates and supports to the pool edge.
Steps for attaching fixing plates to sliders and pool edge.
Instructions for mounting beam boxes to vertical supports on the pool edge.
Method for using chemical sealing with inserts for fixing screws.
Diagrams showing correct positioning for beam fastenings at different levels.
Detailed checks for fuses, relays, voltage, and connections on the control box.
Steps to test the power supply cable for voltage and continuity.
Procedure to test the continuity of key switch contacts.
Steps to check motor sensor operation and physical placement.
To Next Page