Next Wave CNC LCD Pendant

To Next Page

To Previous Page

Next Wave CNC warrants your new Shark LCD Pendant to be free from defects in

material and workmanship for TWO YEARS from the date of purchase. The warranty

applies only to the original retail purchaser of the SHARK LCD Pendant when pur-

chased from an authorized Next Wave CNC distributor. This Warranty covers the parts

and labor to correct the defect. It does not cover the cost of shipping the machine and/

or parts to Next Wave CNC for evaluation or repair.

This warranty does not apply to problems arising from normal wear and tear, misuse, abuse, negli-

gence, accidents, unauthorized repairs, alterations, or lack of maintenance. This warranty is void if the

SHARK LCD Pendant or any portion of it is modified without prior written permission form Next Wave

CNC, or if the machine is located or has been outside the country where the machine was purchased.

Please contact Next Wave CNC to take advantage of this warranty. If Next Wave CNC determines that

your SHARK LCD Pendant is defective in material or workmanship, Next Wave CNC will at its ex-

pense and upon proof of purchase send replacement parts to the original retail purchaser necessary

to cure the defect. Next Wave CNC will repair the SHARK LCD Pendant provided it is returned to Next

Wave CNC, shipping prepaid, with proof or purchase and within warranty period.

Next Wave CNC disclaims all other express or implied warranties, including fitness for a particular

purpose. Next Wave CNC shall not be liable for death, injuries to persons or property, or incidental,

consequential, contingent or special damages arising from the use of the SHARK LCD Pendant.

All other trademarks are the property of their respective owners. Information in this manual is

subject to change without notice. The most recent version of this manual can be found at

www.NextWaveCNC.com/downloads-links

SHARK is the registered trademark of

Next Wave CNC.

Ready2Control is copyrighted by

Next Wave CNC.

Virtual Zero Unlimited is patented by

Next Wave CNC.

Version: 07/04/2022

Watch Getting Started with your LCD Pendant training video at:

https://www.nextwavecnc.com/webinars

Next Wave CNC LCD Pendant - Page 2