3
Notes:
• Only one party can talk on a channel at
a time.
• The TALK indicator on the station you
are using remains lit as long as you
hold down
TALK or CALL, or when you
press
LOCK.
• If your voice sounds distorted, you
might be speaking too loudly or too
close to the microphone.
• Set the channel selector back to your
designated channel after you finish
talking, so others can easily reach you.
Monitoring
You can set any station so it continuously
transmits sounds from the area where it is
located to another station. For example, you
could set the station in a baby’s bedroom,
then use the station in the kitchen to monitor
the sounds.
Note: You can monitor only one station at a
time.
1. Press LOCK on the station in the area you
want to monitor. The TALK indicator
lights.
Note: The TALK indicator stays lit until
you press
CALL or TALK. This lets you
know that the station is transmitting.
2. Set the channel selectors on both
stations to the same channel.
3. When you finish monitoring, release the
lock by pressing
TALK or CALL on the
station in the area you are monitoring.
The TALK indicator turns off.
Note: After pressing LOCK on a station,
you cannot call or talk to that station until
you press
TALK or CALL to release the
lock.
Using Additional Stations
You can add additional stations to your
intercom system as long as they transmit on
the same frequency. Any intercom that
transmits on the same frequencies is
compatible. The intercom’s channels and
transmitting frequencies are shown below:
A ....................................... 200 kHz ±2.5 kHz
B ....................................... 270 kHz ±2.5 kHz
C ....................................... 230 kHz ±2.5 kHz
Stations in the same box have the same
frequency.
Be sure the frequency of the stations you plan
to add matches the frequency of your current
stations. If you want to set up a separate
intercom system, however, be sure it operates
on a different frequency.
INDUSTRY CANADA NOTICE
This equipment complies with the limits of a
Class B digital device as specified in Industry
Canada regulations. These limits provide
reasonable protection against radio and TV
interference in residential areas. However,
this device might cause radio or TV
interference even when it is operating
properly.
Operation is subject to the following two
conditions: (1) This device may not cause
interference, and (2) this device must accept
any interference including interference that
may cause undesired operation of the device.
To eliminate the interference, you can try one
or more of the following:
• Reorient or relocate the receiving
antenna.
• Move your device away from the receiver.
• Connect your device to an outlet that is
on a different electrical circuit from the
receiver.
Contact your local electronic store for help
if the problem persists.
This digital apparatus does not exceed the
Class B limits for radio noise emissions from
digital apparatus.
To Next Page
Loading...